Electrical Specification

Input voltage:

+24V d.c. ±0.5V at 0.7A & -15V d.c. ±0.5V at 0.02A.

Output Voltage:

±5kV limited to 500uA in Voltage Mode, ±8kV at 35uA in Current mode.

Control:

Vctrl Mode : 0 to +10V gives 0 to ±5 kV limited to 500uA
Ictrl Mode : 0 to +10V gives 0 to ±35uA sourced from ±8 kV.

Voltage Monitor:

0 to ±10V represents 0 to ±5kV, ±5%. Source resistance 400k ohm.

Polarity:

Reversible selection is by grounding of appropriate control lines.
(Current less than 25 mA.)

Line regulation:

< 100ppm for 1V change in input voltage.

Load regulation:

< 100ppm for 10% to full load.

Ripple:

< 1 volt peak to peak.

Temperature co-efficient:

<150ppm/ °C

Operating temperature:

0 °C to +45°C.

Current Monitor (pin 7):

0 to +10V represents 0 to ±35uA. Source resistance 10k ohm. Tol ±5%.

Mechanical Specification

Size:

160mm x 145mm x 48mm.

Output cables:

By flying lead type URM43 length 0.5 metres.

Input Connector:

10 pin Molex.

Connections

Pin 1 Mode control - +24V = Current Mode
                               0V or o/c = Voltage Mode
Pin 2 +24V DC
Pin 3 Voltage Monitor o/p
Pin 4 -15V DC supply
Pin 5 V control i/p
Pin 6 -ve O/P Polarity select - to 0V
Pin 7 Current Monitor o/p
Pin 8 +ve O/P Polarity select – to 0V
Pin 9 Signal 0V
Pin 10 Power 0V